X

Chapter 3 ES2 61
Control ES2 modulation intensity with via sources
In a basic modulation routing comprised of a target and source, you can set a xed modulation
intensity by vertically dragging the Intensity slider to the right of the routing. The slider value
always denes a constant modulation intensity.
You can choose a further modulation source from the via pop-up menu, which controls
modulation intensity.
Choosing a value other than o for via divides the Intensity slider into two halves. Each half has
its own arrowhead.
•
The upper half of the slider denes the maximum modulation intensity when the via
controller is set to its maximum value.
•
The lower half of the slider denes the minimum modulation intensity when the via
controller—the modulation wheel, for example—is set to its minimum value.
•
The area between the two slider halves denes the modulation range of the via controller.
Create a modulation routing that includes a via source
1 Choose a modulation target from the Target pop-up menu.
2 Choose a modulation source from the Source pop-up menu.
3 Choose the modulation source that you want to use for control of modulation intensity from the
via pop-up menu.
4 Vertically drag the upper arrowhead of the Intensity slider (to the right of the modulation
routing) to set the maximum modulation intensity.