User manual

-5-
III. Installing the SeriTek/1SM2
Introduction
This section describes the proper method of installing your SeriTek/1SM2.
Caution: Please make sure your data is backed up prior to installing the SeriTek/1SM2
CardBus adapter and hard drive(s) or peripheral(s).
The SeriTek/1SM2 CardBus adapter and your Macintosh contain sensitive components that
can be permanently damaged by Static Electric Discharge. To minimize the chance of
Electro-Static Discharge avoid touching the CardBus connector, handle only the edges of the
card (do not touch the interface connector) and work in an area free of static electricity.
Note: Prior to using you SeriTek/1SM2 disable Sleep Mode by adjusting the Energy Saver to
never allow the sleep function on the system when the SeriTek/1SM2 is installed, if you need
to sleep the system first un-mount drives attached to the SeriTek/1SM2 and unplug the
adapter.
Figure 1: Disabling Sleep Mode When Using the SeriTek/1SM2