User Guide

Mac mini (Mid 2010) Take Apart — Antenna Plate 114
2010-08-03
2 Slide the antenna
plate into place on
the housing.
Note: The edge of the
plate has a slot that
the edge of the
housing must t into
for the plate to sit at
and the screw holes
to align. (see rough
cross-section example
at right)
3 A tool, such as the
hex wrench, inserted
slightly into one of
the plate holes may
help to maneuver.
Be careful not to
damage the cosmetic
Mylar on the hard
drive, or allow the
tool to damage the
housing.
4 If the plate is not
seated properly you
will see that it is not
resting in the recess
on the housing and
the screw holes are
not aligned.
5 Install the 4 screws.