3.5

295MainStage Effects
Use the SpaceDesigner Spread parameters
The X-Over (crossover) slider setting and Hi and Lo Spread knob values enhance the
perceived width of the signal. This occurs without losing the directional information of the
input signal normally found in the higher frequency range. Low frequencies are spread to
the sides, reducing the amount of low frequency content in the center—allowing the reverb
to encompass the mix.
• In MainStage, set the level of the Spread knobs and fields: Rotate to extend the stereo
base to frequencies below or above the frequency determined by the X-Over parameter.
• At a Spread value of 0.00, no stereo information is added. The inherent stereo
information of the source signal and reverb, however, is retained.
• At a Spread value of 1.00, left and right channel divergence is at its maximum.
• Set the X-Over slider and field value: Set the crossover frequency in hertz. Any impulse
response frequency below or above the value you set is affected by the Lo and Hi
Spread parameters (at values over zero).
Note: These parameters have no impact when you use SpaceDesigner as a mono plug-in.