3.5

53MainStage Effects
Use the MainStage DelayDesigner Tap display
The view buttons determine the parameter shown in the Tap display.
The Toggle bar is shown below the view buttons. You can use it to turn parameters on or
off for each tap.
You can use the Overview display to zoom and to navigate the Tap display area.
Tip: If the Overview display is hidden behind a tap, you can move it to the foreground by
holding down Shift.
Select the parameter shown in the Tap display
• In MainStage, click one of the following buttons to select the parameter or parameters
shown in the Tap display.
• Cutoff button: Show the highpass and lowpass filter cutoff frequencies of taps.
• Reso(nance) button: Show the filter resonance value of each tap.
• Transp(ose) button: Show the pitch transposition of each tap.
• Pan button: Show the pan parameter of each tap.
• For mono to stereo channels, each tap contains a line showing its pan position.
• For stereo to stereo channels, each tap contains a dot showing its stereo balance.
A line extending outward from the dot indicates stereo spread.
• Level button: Show the relative volume level of each tap.
Tip: Press Option-Command to temporarily switch the Tap display to Level view
from another view.