3

Chapter 13 Space Designer convolution reverb 242
m Rotate the IR Start knob to shift the playback start point of the impulse response.
This eectively cuts o the beginning of the impulse response, which can be useful for
eliminating level peaks at the start of the impulse response sample.
Use Space Designer output parameters
Space Designer’s global parameters aect the overall output or behavior of the eect. See
Space Designer global parameters overview.
The tasks below cover the use of Space Designer’s output parameters.
Set Space Designer mono/stereo output parameters
Use the output parameters to adjust the balance between the direct, or dry, signals and
the processed signals. The parameters that are available depend on Space Designer’s input
conguration.
Space Designer provides two output sliders—the Dry slider for the direct signal, and the Rev
slider for the reverb signal—when you insert it as a mono, mono to stereo, or stereo eect.
Mono/Stereo Surround
m To set the level of the Dry slider: Move to set the level of the non-eect, or dry, signal. Move the
slider to a value of 0 (mute) if Space Designer is inserted in a bus channel or you are using
modeling impulse responses, such as speaker simulations.
m To set the level of the Rev(erb) slider: Move to adjust the output level of the eect, or wet, signal.