User Manual
Table Of Contents
- MainStage User Manual
- Contents
- An Introduction to MainStage
- Setting Up Your System
- The MainStage Interface
- Getting Started With MainStage
- Before You Begin
- Choosing a Concert Template
- Selecting and Playing Patches
- Adding a Patch
- Renaming a Patch
- Adding a Channel Strip to a Patch
- Changing a Channel Strip Setting
- Learning Controller Assignments
- Mapping Screen Controls to Parameters
- Trying Out Full Screen and Perform Modes
- Customizing the MainStage Window
- Working With Concerts
- Working in Edit Mode
- Working With Patches in Edit Mode
- Working With Channel Strips in Edit Mode
- Selecting Channel Strips
- Choosing Channel Strip Settings
- Resetting a Channel Strip
- Editing Channel Strips in MainStage
- Renaming a Channel Strip
- Choosing the Channel Strip Color
- Changing the Channel Strip Icon
- Showing Signal Flow Channel Strips
- Creating Keyboard Layers and Splits
- Setting the Velocity Range and Offset
- Creating Controller Transforms
- Filtering MIDI Messages
- Deleting Channel Strips
- Mapping Screen Controls
- Working With Sets in Edit Mode
- Working at the Set Level
- Overriding Concert- and Set-Level Mappings
- Sharing Patches and Sets Between Concerts
- Working in Layout Mode
- Performing Live With MainStage
- Key Commands
- Setting MainStage Preferences
- Index
Chapter 8 Performing Live With MainStage 87
When performing, keep in mind the difference between patch parameters and
parameters controlled at the concert level. When you select a patch, its parameters are
set to the values at which you last saved the patch. If you have previously played the
patch since you opened the concert, they are set to the values at which you left them
when you played the patch. Parameters at the concert level, however, remain at their
current value when you select new patches. For example, if you select a patch with a
channel strip set to a volume 0 dB, but the Master volume fader at the concert level is
set to –96 dB, you will hear silence, not full volume. Similarly, parameters controlled at
the set level remain at their current value when you select a different patch in the set.
Also keep in mind that when you select a patch, the screen controls for knobs, faders,
and other controls in the workspace show the parameter values for the patch, which
may be different than the positions of the physical controls on your controller. When
you move the physical controls, the screen controls instantly update to show the
current value.
Selecting Patches Using Key Commands
You can select patches in the patch selector using the following key commands:
Selecting Patches Using Actions
If you have mapped screen controls to actions for selecting patches, such as selecting
the previous or next patch, you can select the patches using the physical controls
assigned to those screen controls as you perform. You can also select sets or the
concert using actions. Buttons are particularly useful for selecting patches, sets, or the
concert using actions.
When selecting patches using actions, skipped patches are also skipped. For example, if
you use a screen control mapped to select +10 patches, any skipped patches would not
be counted in the +10.
Key command Selection
Up Arrow The previous patch
Down Arrow The next patch
Left Arrow The first patch in the previous set
Right Arrow The first patch in the next set