Owner's Manual
Regulatory
Complianc
e Information
FCC Complia
nce
Stat
em
ent
This
device
cq_.mplies
with part
15
of
the
FCC
rules.
Operation
is
subject to the following
two conditions: (1)
This
device
may
not
cause
harmf
ul
interference,
and
(2)
this device
must accept
any
interference r
ece
i
ved,
including interference that
may
cause
undesired
operation.
Note:
This
equipment
has
been
tested
and
found to comply with the lim
its
for a
Class
8
digital device, pursuant to part
15
of
the
FCC
Rules
.
These
limits
are
designed to provide
reasonable protection against harmful interference in a residential installation.
Th
is
equipment
generates,
uses,
and
can
radiate radio frequency energy
and,
if
not i
ns
talled
and
used
in
accordance
with the instructions,
may
cause
ha
rmf
ul
interference to radio
communications.
However,
there
is
no
gu
ar
antee
that interference will not occur
in
a
particular install
at
i
on.
If this equipment d
oes
cause
harmful interference to
rad
io
or
television reception, which
can
be determined
by
turning the equipment off
and
on,
the
user
is
encouraged to try
to correct the interfe
rence
by
one
or
more
of
the following
measures:
Reorient
or
relocate the
receiv
ing
antenna.
Increase
the separation between the equipment
and
receiver.
Connect the equipment to
an
outlet
on
a
ci
rcuit different from that to which the
receiver
is
connected.
Consult the
dea
ler or an
experienced
radio/TV technician for
help.
If
n
ecessary,
consult
an
Apple Authorized
Service
Prov
ider
or
Apple.
See
the
service
and
su
pport information that
came
with your Apple product.
Or,
consult
an
experienced
radio/television technician for additional
suggestions.
Impo
rt
ant:
Changes
or
modifications to this product not authorized
by
Apple
cou
ld
void the electromagnetic compatibility
(E
M
C)
and
wi
re
less
compliance
an
d negate your
authority to operate the product.
This
product
has
demonst
rated
EMC
compliance under
conditions that included the
use
of
comp
li
an
t peripher
al
d
evices
and
shielded
cables
between
sys
t
em
components. It is important that you
us
e compliant peripheral
devices
and
shielded
cab
l
es
between
system
components to
reduce
the
pc)ssibility
of
causing
interf
erence
to
radios,
telev
isions,
and
other electronic
devices.
This
product
was
tested
for
EMC
compliance under conditions that included the
use
of
Apple peripheral
devices.
Responsible
porty (contact for
FCC
matters
only):
Apple
Inc.
Corporate Compliance
1 Infinite
Loop,
MS
91
-1
EMC
Cupertino,
CA
9501
4
Canadian Compliance S
tat
ement
T
his
device complies with Industry
Canada
lic
ense
-e
xempt
RSS
st
a
ndard(s).
Operation
is
subject to the following two conditions: (1) this dev
ice
may
not
cause
interference,
and
(2)
this device must accept
any
interference, including interference that
may
cause
undesired operation
of
the
device.
Cet
appareil
est
conforme
aux
normes
CNR
e
xe
mptes
de
li
cence
d'lndustrie
Canada.
Le
functionnement
est
soum
is
aux
deux
con
ditions suivantes:
(1)
cet appareil ne doit
pas
provoquer d
'i
nterferenc
es
et
(2)
cet
appareil doit
accepter
toute interference, y compris
celles
susceptibl
es
de provoquer un fonctionnement non souhaite de l'appareil.
Industry C
an
ada S
ta
tement
Complies with
CAN
ICES-3
(B)/
NMB
-3(8).
Conforme a la norme
CAN
ICE5-3
(B) /
NMB
-3
(8).
14