Instruction Manual

Chapter 6 Create and manage projects 156
However, If you apply the same lter to the group, all layers in that group are aected by the
lter, as if they were a single layer.
Many lters produce dierent results when applied to a group, rather than individual layers in a
group, as shown in the images below.
Filter applied to each layer in groupFilter applied to group
Select layers and groups
To reorganize layers and groups in a project, you must select which ones to move. This section
covers the methods to select layers in the Layers list.
Select one layer or group
m Click a layer or group in the Layers list.
Doing so deselects all other selected objects.
Note: Selecting a group does not also select the layers nested underneath it. However,
operations performed on a selected group also aect layers nested in it.
Select multiple contiguous layers or groups
Do one of the following:
m Shift-click any two layers in the Layers list.
Doing so selects both layers, and all layers in between.
m Click to the left of the thumbnail column and drag up or down to select multiple layers. (This
method works only when you begin dragging above the rst or below the last object.)
67% resize factor