Instruction Manual

Chapter 19 Filters 762
This lter causes rasterization in 3D groups. For more information on rasterization, see Groups
and rasterization on page 1045.
Original image
Gradient Blur filter applied
Parameters in the Inspector
•
Point 1: Sets the position of the start point of the gradient. Drag the Point 1 onscreen control
(the lower-left point) to adjust the X and Y position of the blur start point in the Canvas.
•
Point 2: Sets the position of the end point of the gradient. Drag the Point 2 onscreen control
(the upper-right point) to adjust the X and Y position of the blur end point in the Canvas.
•
Amount: Sets the radius of the blur.
•
Crop: Sets whether the object is cropped at its original boundaries.
•
Mix: Sets the percentage of the original image to be blended with the blurred image.
•
Publish OSC: Publishes the lter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see Final Cut Pro X templates overview on page 385.
Prism
Blurs and refracts the image as if seen through a prism, creating a rainbow eect.
Original image
Prism filter applied
Parameters in the Inspector
•
Amount: Sets the radius of the blur. Drag the arrow onscreen control inward and outward to
adjust the amount (and angle) of the blur in the Canvas.
•
Angle: Sets the angle of refraction. Drag the arrow onscreen control in an arc to adjust the
angle of the blur in the Canvas.
•
Crop: Sets whether the object is cropped at its original boundaries.
•
Mix: Sets the percentage of the original image to be blended with the blurred and
refracted image.
•
Publish OSC: Publishes the lter’s onscreen controls in Final Cut Pro X. For more information on
creating content for use in Final Cut Pro, see Final Cut Pro X templates overview on page 385.
67% resize factor