Manualshelf

5.5

ManualsBrandsApple ManualsOtherMOTION
931932933934935936937938939940
Table Of Contents
936Motion User Guide
• Blue - Green: Sets the amount of input green added to the output blue. The default
value is 0, which leaves the blue channel unmodified. As this value increases, the
output value of blue increases by the amount of input green multiplied by the value of
Blue - Green.
• Blue - Blue: Sets the amount of input blue added to the output blue. The default value is
1.0, which leaves the blue channel unmodified. As this value increases, the output value
of blue increases by the amount of input blue multiplied by the value of Blue - Blue.
• Blue - Alpha: Sets the amount of input alpha added to the blue channel. The default
value is 0, which leaves the blue channel unmodified. As this value increases, the value
of blue increases by the amount of input alpha multiplied by the value of Blue - Alpha.
• Alpha - Red: Sets the amount of input red added to the output alpha. The default
value is 0, which leaves the alpha channel unmodified. As this value increases, the
output value of pixels with nontransparent alpha increases by the amount of input red
multiplied by the value of Alpha - Red.
• Alpha - Green: Sets the amount of input green added to the output alpha. The default
value is 0, which leaves the alpha channel unmodified. As this value increases, the
output value of pixels with nontransparent alpha increases by the amount of input green
multiplied by the value of Alpha - Green.
• Alpha - Blue: Sets the amount of input blue added to the output alpha. The default
value is 0, which leaves the alpha channel unmodified. As this value increases, the
output value of pixels with nontransparent alpha increases by the amount of input blue
multiplied by the value of Alpha - Blue.
• Alpha - Alpha: Sets the amount of input alpha added to the output alpha channel. The
default value is 1.0, which leaves the alpha channel unmodified. As this value increases,
more alpha is added to the pixels in the alpha channel. Values above 1 have no effect,
unless the alpha is eroded by negative values in other alpha parameters.
• Monochrome: Sets the filter to monochrome mode. In monochrome mode, all three color
channels are affected by the Red controls.
• Allow Mono > 1: Allows monochromatic color channels to be set to values greater than
1. By default, this checkbox is selected. Color values are normally between 0 and 1, but
can go over 1 or below 0 because the project’s bit depth is set to 16 bits per channel.
If this checkbox is deselected, each Red color output control is linked. Moving any of
them causes the others to adjust so the total value remains at 1.0. The filter must be in
monochrome mode for this parameter to be active.
• Include Alpha: Sets whether to include the alpha channel in the mono calculation. The
filter must be in monochrome mode for this parameter to be active.
• Mix: Sets the percentage of the original image that’s blended with the color-corrected
image.