5

Reanalyzing at a Higher Quality
When analyzing, choose Better from the Quality pop-up menu in the Behaviors Inspector.
This may take longer, but the quality of the analysis is higher.
Editing the Analysis Data
If neither of the prior solutions helps, look at the Analyze.Confidence parameter in the
Keyframe Editor, then look for frames where the Confidence parameter falls to very low
values. You can convert the Stabilize behavior to keyframes to create transform keyframes
on the stabilized object. These keyframes can then be edited in the Keyframe Editor. Try
deleting keyframes that create unusual spikes at the frames where the Confidence curve
value was low.
For more information on converting behaviors to keyframes, see Converting Tracks to
Keyframes.
Removing Black Borders Introduced by Stabilizing
When you use the Stabilize behavior, the resulting transformations that smooth or stabilize
the shot cause moving black borders to appear around the edges of the image. Although
this is necessary to achieve the desired effect, you probably don’t want these black borders
to appear in the final shot.
There are a few ways to handle these borders.
Zooming the Clip
You can zoom the clip using the Borders pop-up menu in the Behaviors Inspector. The
disadvantage of this method is the resulting softening of the image, depending on how
much it must be enlarged.
To zoom the clip
µ
In the Behaviors Inspector, choose Zoom from the Borders pop-up menu.
The clip is expanded to the full size of the Canvas, preventing black borders from appearing
around the edges.
Scaling the Output Image to Fit the Original Frame Size
If you want to output the resulting image at the same size as the original, the quickest
fix is to scale the image after the Stabilize analysis. You’ll need to enlarge the image to
the point where all instances of black borders fall outside the edges of the frame. Like
the Zoom option (in the Borders pop-up menu), this method softens the image.
Note: This workflow is a manual version of zooming the clip using the Zoom option from
the Borders pop-up menu.
To scale the stabilized image
1 Select the clip and open the Properties Inspector.
2 Adjust the Scale parameter so the borders no longer appear at the edges of the clip.
1337Chapter 22 Motion Tracking