5

Table Of Contents
Note: Because replicator pattern elements are 2D (flat) objects, the pattern elements are
not visible when you use the orthogonal camera views, such as Left, Right, and Top (unless
the source layer or pattern elements are rotated in 3D space). This is because orthogonal
views are at right angles (perpendicular) to the elements. For more information on using
cameras, see Cameras.
Box Replicator with Face Camera turned off Box Replicator with Face Camera turned on
Displaying Replicator Cell Parameters
The replicator cell parameters modify the individual elements in the onscreen pattern.
In a replicator with only a single cell, the cell parameters appear in two locations: the
lower portion of the Replicator Inspector and the Replicator Cell Inspector. In a replicator
with multiple cells, each cell has its own Replicator Cell Inspector that contains all
parameters for that cell.
To display Cell Controls for a single-cell replicator in the Replicator Inspector
1 In the Layers list, Timeline, or Canvas, select a replicator layer.
2 In the Inspector, open the Replicator pane.
The cell parameters appear in the Cell Controls group.
To display Cell Controls for a single-cell replicator
1 In the Layers list or Timeline, select a cell (located beneath the replicator layer).
2 In the Inspector, open the Replicator Cell pane.
To display Cell Controls for a multi-cell replicator
1 In the Layers list or Timeline, select a cell (located beneath the replicator layer).
2 In the Inspector, open the Replicator Cell pane.
Replicator Cell Controls in the Inspector
These controls appear at the bottom of the Replicator Inspector (for replicators with a
single cell) or in the Replicator Cell Inspector (for replicators with multiple cells).
772 Chapter 15 Using the Replicator