Computer SCSI Cable Replacement Instructions

Power Mac G4 (Mirrored Drive Doors) SCSI Cable - 4
Note: To reach the SCSI cable connector on the back hard drive, you may need to
remove the carrier. If so, use a Phillips screwdriver to remove the mounting screw
that holds the carrier to the chassis. Then pull the carrier lever forward and slide up
the carrier to disconnect it from the chassis. (Figure 4)
Figure 4
3. Disconnect the SCSI cable from the SCSI terminator at the bottom of the chassis.
Installing the Replacement SCSI Cable
1. Connect the SCSI cable to all drives.
2. Reinstall the back hard drive carrier, if necessary.
3. Connect the SCSI cable to the SCSI card.
4. Anchor the double-sided taped areas of the cable inside the enclosure.