Computer Laptop User Manual

6 - PowerBook G4 AirPort Card
2. If removing an existing AirPort Card (if not, skip to step 3), pull back on
the antenna clip to release the antenna connector and allow the card to
rise up slightly, then pull the card from the AirPort connector.
Hold the AirPort Card with one hand and grasp the antenna cable
connector with the other. While being careful not to strain the antenna
cable, firmly pull the connector straight out of the AirPort Card.
Important: If an AirPort Card is not being reinstalled right away, the
antenna cable connector must be replaced into its holder (shown in
step 4) and the loop of the antenna cable pulled up slightly and away
from the edge of the computer case. This prevents the cable from
interfering with the PC card slot, below, or getting pinched during
reassembly.
Also, if the insertion end of the AirPort Card connector is rotated up,
push it down into the level position. This allows the bottom case to
install properly.
3. If the AirPort Card to be installed came with the AirPort adapter,
remove the metal clip and pull the AirPort Card from the adapter. (The
adapter and metal clip are not used with your PowerBook.)
Antenna
Clip
Antenna Cable
Connector
Antenna Cable
AirPort Card
Connector
AirPort
Adapter
Metal Clip
AirPort
Card