User`s guide

6Make sure the hard disk named in the box is the one on which you want to install the

PowerCD software.

If it’s not, click the Switch Disk button until the name of the correct disk

appears.

7Click Install.

Messages appear on the screen describing the progress of the installation.

8 When you see a message asking you to insert the QuickTime disk, insert the disk.

9 When you see a message asking you to insert the PowerCD Setup disk, insert the disk.

10 When you see a message saying that installation was successful, click Restart.

Your Macintosh restarts. The computer can now use discs in your PowerCD.

Turning power on or off

To turn power on or off, press the on/off switch on the top of your PowerCD.

When you turn power on, the message display lights up. (If you are running

your PowerCD on batteries, the message display dims after ten seconds. The

message display will light up again when you press any key on either the

player or the remote control.)

IMPORTANT

Power is available in the CD player even when the player is

switched off. If you need to remove all power to the player, be sure to unplug

the power cord and remove the batteries.

Loading and unloading discs

Loading a disc

1Press the Open button on the top of your PowerCD.

2Pull open the disc compartment door.

3If you’re opening the door for the first time, remove the foam packing insert.

HAPTER