User`s guide

General problems
There is no power.
m Make sure that the ON/OFF switch is set to on.
m If you are using batteries, replace the batteries.
m If your PowerCD is plugged into an electrical outlet, make sure that both
ends of the power adapter are properly connected. Also make sure that
there is power in the electrical outlet. Plug in another device to check.
The remote control doesn’t work.
m Aim the remote control at the player.
m Remove any obstacles that may lie in the signal path.
m Replace the batteries in the remote control.
You can’t make changes to a program, and the word “FULL” appears on the message
display.
m The player’s memory is full. See Chapter 7, “Managing the PowerCD
Player’s Memory.”
Problems viewing Photo CDs on TV
There is no picture on the TV.
m Make sure that the disc is a Photo CD.
m Make sure that the disc label is facing towards the door.
m Make sure that the TV is turned on.
m Make sure you have selected the correct channel or external source on
the TV.
m If the PowerCD is connected to both the TV and your computer, make sure
the computer is turned off.
m Check the video connection.
The picture is distorted.
m Check the disc for marks, and clean it with a soft cloth, wiping from center
to edge.
m Check if the disc is defective by trying another disc.
52
C HAPTER E IGHT