Distributed Processing Setup Guide
Table Of Contents
- Apple Qmaster Distributed Processing Setup Guide
- Contents
- Welcome to Distributed Processing
- Distributed Processing Basics
- Getting Started Quickly
- Preparing a Network for Distributed Processing
- The Minimum You Need to Know
- Example of a Minimal Distributed Processing Network
- Using Compressor AutoClusters
- Other Possible Components of a Distributed Processing Network
- Example of an Expanded Distributed Processing Network
- Sample Setup for Part-Time Processing on Desktop Computers
- Configuring Access for Part-Time Distributed Processing
- Setting Up for Part-Time Distributed Processing with Shake
- Additional Steps for Distributed Processing with Shake
- The Interfaces
- Creating Clusters
- An Overview of Configuring a Cluster
- Configuring Service Nodes and Cluster Controllers
- Creating Clusters with Apple Qadministrator
- About QuickClusters
- Administering Clusters
- Using the Command Line
- Installing Apple Qmaster from the Command Line
- Using the Command Line for Distributed Processing
- Using Scripts to Run Apple Qmaster, Compressor, and Batch Monitor
- Appendix
- Resources for Solving Problems
- Solutions to Common Problems
- Contacting AppleCare Support
Stage 2: Configuring a QuickCluster
Use the Apple Qmaster pane of System Preferences to configure the cluster controller
and service node computers.
To configure the cluster controller and service node computers
1 Open System Preferences.
2 Click the Apple Qmaster button, located in the Other section.
The Apple Qmaster pane appears.
3 If the pane is locked, unlock it by clicking the padlock in the lower-left corner to enter
the administrator name and password.
4 Click Start Sharing.
This creates a QuickCluster with this computer as its controller, and an instance of
processing services for each processor on the computer. For information about multiple
service instances, see Using Virtual Clusters to Make the Most of Multiprocessor Computers.
Stage 3: Adding Service Nodes to a Cluster
Do the following on each computer that you would like to make a service node on your
cluster.
To add a service node to a cluster
1 Open System Preferences.
17Chapter 2 Getting Started Quickly