3
Table Of Contents
- Soundtrack Pro 3 Effects Reference
- Contents
- Introduction to the Soundtrack Pro Plug-Ins
- Delay Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Synchronizing Taps in Delay Designer
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Stereo Delay
- Tape Delay
- Delay Designer
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Utilities and Tools
Flanger Effect
The Flanger effect works in much the same way as the Chorus effect, but it uses a
significantly shorter delay time. In addition, the effect signal can be fed back into the
input of the delay line.
Flanging is typically used to create changes that are described as adding a spacey or
underwater quality to input signals.
• Feedback slider and field: Determines the amount of the effect signal that is routed back
into the input. This can change the tonal color and/or make the sweeping effect more
pronounced. Negative Feedback values invert the phase of the routed signal.
• Rate knob and field: Defines the frequency (the speed) of the LFO.
• Intensity slider and field: Determines the modulation amount.
• Mix slider and field: Determines the balance between dry and wet signals.
Modulation Delay
The Modulation Delay is based on the same principles as the Flanger and Chorus effects,
but you can set the delay time, allowing both chorus and flanging effects to be generated.
It can also be used without modulation to create resonator or doubling effects. The
modulation section consists of two LFOs with variable frequencies.
108 Chapter 8 Modulation Effects