3
Table Of Contents
- Soundtrack Pro 3 Effects Reference
- Contents
- Introduction to the Soundtrack Pro Plug-Ins
- Delay Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Synchronizing Taps in Delay Designer
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Stereo Delay
- Tape Delay
- Delay Designer
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Utilities and Tools
• Level knob and field: Sets the level of the delay added to the ring-modulated or
frequency-shifted signal. A Level value of 0 passes the effect signal directly to the output
(bypass).
Modulating the Ringshifter with the Envelope Follower
The oscillator Frequency and Dry/Wet parameters can be modulated with the internal
envelope follower—and the LFO (see Modulating the Ringshifter with the LFO). The
oscillator frequency even allows modulation through the 0 Hz point, thus changing the
oscillation direction.
The envelope follower analyzes the amplitude (volume) of the input signal and uses this
to create a continuously changing control signal—a dynamic volume envelope of the
input signal. This control signal can be used for modulation purposes.
• Power button: Turns the envelope follower on or off and enables the following
parameters.
• Sens(itivity) slider and field: Determines how responsive the envelope follower is to the
input signal. At lower settings, the envelope follower reacts only to the most dominant
signal peaks. At higher settings, the envelope follower tracks the signal more closely,
but may react less dynamically.
• Attack slider and field: Sets the response time of the envelope follower.
• Decay slider and field: Controls the time it takes the envelope follower to return from
a higher to a lower value.
115Chapter 8 Modulation Effects