3
Table Of Contents
- Soundtrack Pro 3 Effects Reference
- Contents
- Introduction to the Soundtrack Pro Plug-Ins
- Delay Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Synchronizing Taps in Delay Designer
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Stereo Delay
- Tape Delay
- Delay Designer
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Utilities and Tools
Test Oscillator
Test Oscillator generates a static frequency or a sine sweep. The latter is a user-defined
frequency spectrum tone sweep. The Test Oscillator is useful for tuning studio equipment
and instruments.
• Waveform buttons: Select the type of waveform to be used for test tone generation.
• The Square Wave and Needle Pulse waveforms are available as either aliased or
anti-aliased versions—the latter when used in conjunction with the Anti Aliased
button.
• Needle Pulse is a single needle impulse waveform.
• If the Sine Sweep button is active, the fixed oscillator settings in the Waveform section
are disabled.
• Frequency knob and field: Determines the frequency of the oscillator (default is 1 kHz).
• Sine Sweep button: Generates a sine wave sweep (of the frequency spectrum you set
with the Start Freq and End Freq fields).
• Time field: Sets the duration of the sine wave sweep.
• Start Freq and End Freq fields: Drag vertically to define the oscillator frequency at the
beginning and end of the sine sweep.
• Trigger button and pop-up menu: Click the Trigger button to trigger the sine sweep.
Choose the behavior of the Trigger button from the pop-up menu:
• Single: Triggers the sweep once.
• Continuous: Triggers the sweep indefinitely.
• Level slider and field: Determines the overall output level of the Test Oscillator.
163Chapter 13 Utilities and Tools