3
Table Of Contents
- Soundtrack Pro 3 Effects Reference
- Contents
- Introduction to the Soundtrack Pro Plug-Ins
- Delay Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Synchronizing Taps in Delay Designer
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Stereo Delay
- Tape Delay
- Delay Designer
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Utilities and Tools
Getting to Know the AutoFilter Interface
The main areas of the AutoFilter window are the Threshold, Envelope, LFO, Filter, Distortion,
and Output parameter sections.
Filter parameters
Threshold parameter
Envelope parameters
Distortion parametersLFO parameters
Output parameters
• Threshold parameter: Sets an input level that—if exceeded—triggers the envelope or
LFO, which are used to dynamically modulate the filter cutoff frequency.
• Envelope parameters: Define how the filter cutoff frequency is modulated over time.
• LFO parameters: Define how the filter cutoff frequency is modulated by the LFO.
• Filter parameters: Control the tonal color of the filtered sound.
• Distortion parameters: Distort the signal both before and after the filter.
• Output parameters: Set the level of both the dry and effect signal.
AutoFilter Threshold Parameter
The Threshold parameter analyzes the level of the input signal. If the input signal level
exceeds the set threshold level, the envelope and LFO are retriggered—this applies only
if the Retrigger button is active.
78 Chapter 5 Filter Effects