3
Table Of Contents
- Soundtrack Pro 3 Effects Reference
- Contents
- Introduction to the Soundtrack Pro Plug-Ins
- Delay Effects
- Delay Designer
- Getting to Know the Delay Designer Interface
- Getting to Know Delay Designer’s Main Display
- Using Delay Designer’s View Buttons
- Zooming and Navigating Delay Designer’s Tap Display
- Creating Taps in Delay Designer
- Selecting Taps in Delay Designer
- Moving and Deleting Taps in Delay Designer
- Using Delay Designer’s Tap Toggle Buttons
- Editing Parameters in Delay Designer’s Tap Display
- Aligning Delay Designer Tap Values
- Editing Filter Cutoff in Delay Designer’s Tap Display
- Editing Pan in Delay Designer’s Tap Display
- Editing Taps in Delay Designer’s Tap Parameter Bar
- Editing Delay Designer Taps with the Shortcut Menu
- Resetting Delay Designer Tap Values
- Synchronizing Taps in Delay Designer
- Using Delay Designer’s Master Section
- Working with Delay Designer in Surround
- Stereo Delay
- Tape Delay
- Delay Designer
- Distortion Effects
- Dynamics Processors
- Equalizers
- Filter Effects
- Imaging Processors
- Metering Tools
- Modulation Effects
- Pitch Effects
- Reverb Effects
- Space Designer Convolution Reverb
- Getting to Know the Space Designer Interface
- Working with Space Designer’s Impulse Response Parameters
- Working with Space Designer’s Envelope and EQ Parameters
- Working with Space Designer’s Filter
- Working with Space Designer’s Global Parameters
- Using Space Designer’s Input Slider
- Using Space Designer’s Latency Compensation Feature
- Using Space Designer’s Definition Parameter
- Using Space Designer’s Rev Vol Compensation
- Using Space Designer’s Output Sliders
- Working with Pre-Dly (Predelay) in Space Designer
- Using Space Designer’s IR Start Parameter
- Using Space Designer’s Spread Parameters
- Automating Space Designer
- Specialized Effects and Utilities
- Utilities and Tools
Using the MultiMeter Peak Parameters
The MultiMeter Peak parameters are used to enable/disable the peak hold function and
to reset the peak segments of all meter types. You can also determine a temporary peak
hold duration.
• Hold button: Activates peak hold for all metering tools in the MultiMeter, as follows:
• Analyzer: A small yellow segment above each 1/3 octave level bar indicates the most
recent peak level.
• Goniometer: All illuminated pixels are held during a peak hold.
• Correlation Meter: The horizontal area around the white correlation indicator denotes
phase correlation deviations in real time, in both directions. A vertical red line to the
left of the correlation indicator shows the maximum negative phase deviation value.
You can reset this line by clicking it during playback.
• Level Meter: A small yellow segment above each stereo level bar indicates the most
recent peak level.
• Hold Time pop-up menu: When peak hold is active, sets the hold time for all metering
tools to 2, 4, 5, or 6 seconds—or infinite.
• Reset button: Click to reset the peak hold segments of all metering tools.
Surround MultiMeter
The surround version of the MultiMeter is specifically designed for analysis and metering
of multichannel surround files. You can view either the Analyzer, Goniometer, or Correlation
Meter results in the main display area. Use the controls on the left side of the interface
to switch the view and set other MultiMeter parameters. The (Peak/RMS) Level Meter is
visible on the right.
96 Chapter 7 Metering Tools