Effects Reference

Chapter 11 Convolution Reverb: Space Designer 139
The EQ has the following parameters:
 EQ On/Off button: Click to switch the entire EQ section on or off.
 Individual EQ buttons (1 through 4): Click to turn individual EQ bands on or off.
 Frequency: Sets the frequency for the selected EQ band.
 Gain: Adjusts the gain cut or boost for the selected EQ band.
 Q: Sets the Q-factor for the two parametric bands. The Q can be adjusted from 0.1
(very narrow) to 10 (very wide).
You can edit the EQ parameters numerically in the parameter bar or graphically on the
main display. Move the mouse horizontally over the display. When your mouse cursor is
in the access area of a band, its individual curve and parameter area will be highlighted
and a pivot point appears.
 Drag any band to the right or left to adjust its frequency.
 Drag any band up to increase the gain, or down to lower the gain.
 Position the pointer directly on the (illuminated) pivot point of a parametric band
and drag up to raise the Q or down to lower the Q.
Automating Space Designer
Space Designer cannot be fully automated as per most other Soundtrack Pro plug-ins.
This is because Space Designer needs to reload the impulse response (and recalculate
the convolution) before audio can be routed through it.
You can, however, record, edit, and play back any movement of the following Space
Designer parameters:
 Stereo Crossfeed
 Direct Output
 Reverb Output