Effects Reference

Chapter 1 Delay 21
You can also hold down the Command key and click the Tap display before dragging.
This results in a line trailing behind the pointer. The values of the taps are aligned along
the line when you release the mouse button.
Option-clicking a tap resets the chosen parameter to its default setting. If multiple taps
are selected, Option-clicking one tap resets that parameter to its default value for all
selected taps.
Editing the Filter Cutoff Parameters in the Tap Display
While the steps outlined above apply for most graphically editable parameters, the
Cutoff and Pan parameters work in a slightly different fashion.
In the Cutoff view, each tap actually shows two parameters—highpass and lowpass
filter cutoff frequency. The filter cutoff values can be adjusted independently by
dragging the specific cutoff frequency line (upper line is highpass, lower line is
lowpass), or both cutoff frequencies can be adjusted by dragging between them.
When the highpass filter cutoff frequency value is lower than that of the lowpass cutoff
frequency, only one line is shown. This line represents the frequency band that passes
through the filters (in other words, the filters act as a bandpass filter). In this
configuration, the two filters operate serially, meaning the tap first passes through one
filter, then the other.