User manual

µ
Double-click either time ruler to stop playback and move the position line to the clicked
location.
Moving the Position Line
You can move the position line directly to any location.
To move the position line
Do one of the following:
µ
Click once at the point you want to place the position line—on either time ruler.
Double-click if you want playback to start immediately.
µ
Drag the position line to a new point. This can be done when the mouse is in either time
ruler or an empty track.
Note: Selecting a region, track, or marker in the CD Tracks or Regions lists sets the playback
position to the beginning of the region, track, or marker.
Looping Playback
You can loop (or cycle) a section of your project so that it plays back repeatedly. This can
be useful when editing a part of the project where you want to hear the results of your
edits in real time. You can loop playback between two points by defining a cycle area in
either time ruler, and pressing Play or the Space bar.
To define a cycle area
µ
In either time ruler, drag from the desired loop start position to the point where you want
looping to end.
Drag either of the cycle area handles to resize an existing cycle area.
You can also grab the center of the cycle area to move it, without changing the cycle
length.
To remove the cycle area
µ
Click anywhere outside the current cycle area in the time ruler. Note that this will move
the position line to the clicked point.
Navigating in the Wave View Area
Navigation in the Wave View area is performed with the zoom controls and scroll bar.
You can also move to different parts of the Wave View area by using the rectangle in the
Overview.
You can zoom in to make precise edits, or zoom out to see more of your project.
32 Chapter 2 Getting Started with WaveBurner