User manual

2 Drag the envelope point to the right to set the length of the fade-in.
As you drag, the envelope changes to show the length of the fade.
To manually add a fade-out
1 Move the pointer over the fade-out handle located on the volume envelope—at the right
edge of the region. The pointer changes to the Fade tool.
2 Drag the envelope point to the left to set the length of the fade-out. As you drag, the
envelope changes to show the length of the fade.
To create an automatic fade
µ
When you drag a region (in the Wave View area) to a position that overlaps an adjacent
region, the overlapping portions of the regions are automatically crossfaded—a fade-out
is added to the earlier region, and a fade-in is added to the later region.
Note: This automatic fade functionality only applies if you haven’t already created a fade
manually.
To restore the automatic setting of a manually edited fade
1 Move the Fade length handle to the position that coincides with the beginning (or end)
of the other overlapping region.
40 Chapter 3 Working with Regions