User manual

Bounce Preferences
The Bounce preferences define the behavior of WaveBurner’s Bounce functions.
Dithering pop-up menu: Choose the type of dithering that is applied when the project
is bounced or burned. The choices are POW-r #1 (Dithering), POW-r #2 (Noise Shaping),
POW-r #3 (Noise Shaping), and No Dithering.
For information about when to use dithering, and the differences between the dithering
types, see the Logic Pro User Manual.
Replace Region With Bounce checkbox: When enabled, the new audio file created by
choosing Region > Bounce Region replaces the original region.
Note: This does not apply if the original file is stereo and the bounced audio file is
mono—as information would be lost when the stereo file was replaced by the mono
file.
Clipping Detection Stops Bounce checkbox: When enabled, the bounce process is stopped
when clipping is detected—in either the region or project being bounced.
Rendering Delay field: Specifies the number of seconds that need to elapse—following
an editing or processing operation—before auto rendering begins.
Faster Auto Rendering checkbox: Enable to allocate more processing resources to auto
rendering.
Note: This may slow down the responsiveness of the user interface.
Save Rendering Data to Document File checkbox: Enable to save rendering data with
your project. This is most suitable for large, complex projects. You should disable this
option for simpler projects.
75Chapter 8 Setting WaveBurner Preferences