Cut Sheet

Effective September, 2005
Copyright 2005
800-621-1506
www.appletonelec.com
PAGE 19
M- 19
M
NPBRKT Nameplate Mounting Bracket
For use with EFDB, EFS, Contender
®
and N1/N2 Series
Control Stations, Tumbler Switches and Manual Motor Starters.
Applications
•
For mounting on EFDB, EFS, Con-
tender and Intraground series control
stations to make circuit description/
identification easy.
Features
•
Pre-drilled holes in bottom of bracket
allow direct mounting to Appleton EFDB,
EFS, Contender and intraground series
control stations with existing cover bolts
(Intraground series bracket is mounted
using nameplate screws).
•
Pre-drilled holes in middle of bracket
allow mounting of customer’s circuit
identification nameplate; epoxy glue
may also be used for mounting (phe-
nolic nameplate not included).
•
Nameplate mounting bracket is cor-
rosion resistant stainless steel.
•
Bracket eliminates costly field instal-
lation of drilling and tapping to accom-
modate circuit identification nameplate.
•
Brackets fit side-by-side on 2, 3 and
4 gang boxes and 3 Device EFD Se-
ries.
Description Catalog Number*
Nameplate Mounting Bracket for EFDB and EFS series NPBRKT-EFDB
Nameplate Mounting Bracket for Contender
®
and 3 Device EFD Series NPBRKT-C0NT
Nameplate Mounting Bracket for N1/N2 series NPBRKT-N1N2
* To order bracket with either series control station or manual motor starter, add
suffix–NPBRKT to end of catalog number.
Note: Mount bracket between cover
screws and cover. Do not mount brack-
et between ground joint flame path
between cover and back box.
Dimensions (In Inches):
Secure
bracket
under cover
screws of
box.
Torque
cover
screws to
12ft - lbs.
Catalog No. A B C D E
NPBRKT-CONT 2.81 2.50 3.38 2.75 .27 x .33
NPBRKT-EFDB 2.38 2.50 3.00 2.75 .25
NPBRKT-N1N2 2.13 2.25 2.75 2.69 .16
1.00
2.00