Wiring Diagram/Installation Instructions

6
INDUCTION COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
1. Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 7).
Screws
Figure 7
2. Install the retainer brackets. See Figure 8.
The retainer brackets MUST be installed, to meet
local codes or, in their absence, with the National
Electrical Code ANSI/NFPA No. 70—latest edition
(see Figure 8).
2mm
Figure 8
Cooktop
Spring
Spacer
Countertop
Retainer
Bracket
Checking Operation
Refer to the Use and Care Guide for operation.
CAUTION
Do not touch cooktop glass or elements.
They may be hot enough to burn you.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this appliance.
Refer to your Use and Care Guide for service phone
numbers.
WARNING
Do not remove the spring spacers on
the edges of the cooktop. These spacers center the
cooktop in the space provided. The cooktop must
be centered to prevent excess heat buildup that
may result in heat damage or fire (see Figure 10).
4. Fix the cooktop to the bracket using the screws
supplied (see Figure 10).
Figure 10
Spring
Spacer (8)
Retainer bracket (2)
Position brackets on
unit cutout center line
as shown.
Hole located
under the
burner box to
fix the retainer
bracket.
Granite countertop Installation Kit
A Granite Countertop Installation kit # 903061-9010 can
be ordered through a Service Center or by phone at 1-877-
ELECTROLUX (1-877-435-3287).
3. Set the cooktop into the countertop cutout.
A B
During the installation with a wide cutout make sure the
cooktop is centered. A and B gap should have the same
dimensions. The elongated holes on the bottom of the
installation brackets are made to fit every cutout.
Figure 9