Installation guide

3377

If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice

and release it to advance to Channel 3. Then press it once more and

HHOOLLDD

it. The horn will honk three times (if

connected) and the LED will flash three times to confirm it is ready to receive the code from the transmitter.

LLeeaarrnn RRoouuttiinnee wwiillll bbee eexxiitteedd iiff::

■ Door is closed.

■ Ignition is turned off.

■ Program switch is pressed too many times.

■ More than 15 seconds between steps.

ttrraannssmmiitttteerr ccoonnffiigguurraattiioonnss

The transmitters can be programmed with the standard or single button arm/disarm configurations by using the

Auto Learn functions in the Transmitter/Receiver Learn Routine.

A remote that uses the standard configuration operates similarly to many factory keyless entry remotes. A stan-

dard configuration transmitter allows arming, disarming, and Panic Mode activation with separate buttons. When

programmed for standard configuration, the transmitter buttons are assigned to the following functions:

.................................operates...........................Arm/Lock,

Panic ON/Panic OFF

.................................operates...........................Disarm/Unlock/

panic off

.................................operates...........................Remote start

.................................operates...........................Channel 2—trunk

release

and ................operate............................Timer Mode

and ................operate ..........................Short Run/Turbo

timer

and ................operate............................Channel 4

ssttaannddaarrdd ccoonnffiigguurraattiioonn