Installation guide

ManualsBrandsApplica ManualsCoffee MakerAM7

4488

33--11 EENNGGIINNEE CCHHEECCKKIINNGG OONN//

OFF

In the default setting the remote start will monitor either the vehicle's tach wire

or voltage depending on the programming of feature 3-2. If programmed OFF the vehicle will crank for the pro-

grammed crank time (feature 3-5) and will not verify with tach or voltage that the car is running. In the OFF

setting, if the vehicle fails to start, the ignition can stay on for the entire run duration. Using tach or voltage

check is always recommended if possible.

33--22 CCHHEECCKKIINNGG TTYYPPEE TTAACCHH//

VOLTAGE

Selects the method of engine monitoring. If set to TACHOMETER the unit will

reference the learned tach signal to disengage the starter. In addition it will monitor the RPM and shut down if

the engine RPM is too high or too low. When set to VOLTAGE, the unit will crank the starter for the programmed

time and then attempt to sense that the engine is running by detecting an increase in voltage. The threshold

for the voltage check is selectable in feature 3-6.

33--33 RRUUNN TTIIMMEE 1122,,

MMIINNUUTTEESS::

Selects the time in minutes that the system will operate the engine

until the system "times out". This is the maximum operation period and the system may be shut down

using a shutdown at any time. Using the Bitwriter®, the run time can be programmed for any duration from 1-

60 minutes.

33--44 PPAARRK

KIINNGG LLIIGGHHTTSS FFLLAASSHHIINNGG//

CONSTANT

In the default setting, the unit will flash the vehicle's parking lights

(if connected) while remote started. The constant setting will turn the parking lights on solid for the entire run

duration.

33--55 CCRRAANNKK TTIIMMEE 00..66//

0.8

1.0

1.2

1.4

1.6

1.8

2.0

4.0

SSEECCOONNDDSS::

If the unit is programmed for no engine check-

ing or voltage sense, the crank time must be set to the appropriate duration. The default setting is 0.6 second.

If a different crank time is desired, select feature 3-5 and select either 0.6 second by using the one-chirp setting

or toggle through the higher settings by using the two-chirp settings.

33--66 VVOOLLTTAAGGEE CCHHEECCKK HHI

I//

LOW

This feature only functions when programmed for voltage sense. Some vehicles have

many accessories, which are turned on when remote started. In these vehicles, the variation of voltage between

the engine off and the car running is very small and the remote start unit may "think" the vehicle has not

started. This can cause the remote start to shut-down after the car has been started. If this happens program

this feature to the LOW position.

33--77 SSHHOORRTT RRUUNN//TTUURRBBOO 11//

MMIINNUUTTEESS::

When the and buttons on the transmitter are pressed

simultaneously, the vehicle will start for the programmed short run time. The factory default is 1 minute.

33--88 AACCTTIIVVAATTIIOONN PPUULLSSEE CCOOUUNNTT

//22::

This allows the system to use 1 or 2 pulses to activate the remote start

sequence. The default setting is 2-pulses.

NNoottee::

1 or 2 pulses on the WHITE/BLUE remote start activation input wire as well as the

button of the remote control.

mmeennuu ##33 -- rreemmoottee ssttaarrtt ooppttiioonnss