PLEASE READ AND SAVE THIS USE AND CARE BOOK. ® FOR SINGLE-CAT HOUSEHOLDS Lucy USA/Canada www.littermaid.
IMPORTANT SAFEGUARDS ☐ NOT INTENDED FOR USE WITH KITTENS UNDER SIX MONTHS. ☐ Not intended for use by handicapped, incapacitated or older cats that might experience difficulty in entering or leaving the litter box. ☐ PREGNANT WOMEN and IMMUNE-DEFICIENT PEOPLE should avoid contact with cat waste at all times. ☐ CAUTION: THIS IS NOT A TOY. The LitterMaid® Self-Cleaning litter box is a precision-operated appliance.
Setup Instructions Accessories 5 No Tools Required for Setup • Unpack the pieces of the unit: LitterMaid® litter box, AC adapter (packed in paper pulp), disposable waste receptacles, LitterMaid® scoop and rake cleaner, use and care book and cleaning brush (packed with disposable waste receptacles), plus any optional items including the carbon filters, paw-cleaning ramp and litter box carpet. • Cut and remove the restraints on each end of the rake.
• Remove the AC adapter from paper pulp packaging and plug it into the unit. Then plug cord into a standard electrical wall outlet. Press the On/Off button to "on" and a green light will appear at top of unit. The rake will automatically run through its first cleaning cycle and smooth out litter. Optional Items Litter Box Carpet • Place assembled unit on carpet. Paw-Cleaning Ramp • The paw-cleaning ramp has two holes that snap into the pivot pins on the inside of waste receptacle compartment cover.
Troubleshooting A. Rake continues to go through cleaning cycles. Probable Causes: • Too much litter in litter box is causing excess litter to collect behind rake, preventing it from returning to home position. If the rake cannot move an obstacle during the cleaning cycle, unit will go through a cleaning cycle up to five times in an attempt to clear the obstacle.
Probable Cause: • Power outage or batteries are incorrectly installed. 1. Turn On/Off button to “off” then back to “on.” 2. Make sure there is power to the unit and/or batteries are correctly installed. G. Light blinks slowly and continuously. Probable Cause: • Rake has encountered an obstacle it cannot remove. If rake cannot move an obstacle during the cleaning cycle, the unit will go through a cleaning cycle up to five times in an attempt to clear obstacle.
• Use only premium clumping litter refill litter tray to just below the "Max Line". • Plug in AC power adapter and replace batteries. • Turn the On/Off button to "on" to reactivate automatic operation. Paw-Cleaning Ramp • • • • Remove mat by gently pulling on fabric strip provided (Fig. 9). Mat is held in place by 5 tabs and will remove easily. Just remove and clean carpet by using a vacuum cleaner. To return it to its original position, reinsert carpet under tabs.
• Push rake into the motor housing until it snaps into place both on top and on the bottom of the rake (Fig. 14 and 15). • Press On/Off button and hold it for 3 seconds, the LED stops blinking and motor housing returns to home position. Note: The motor housing will automatically return to the home position, 5 minutes after activating the cleaning cycle. • Unit is now ready for normal operation.
Copyright © 2008 Applica Consumer Products, Inc.