User's Manual

Page 10

There are 2 types of FXConnectX Remotes that can be used: Body or Floor Units. All styles are

the StagePro8 system.

Both remote styles incorporate status LED’s that serves multiple purposes. The LED will flash

Green to indicate that the unit is transmitting whenever a button is pressed. The LED will also

show status of the battery. If the LED shows solid RED this indicates that the battery is low and

needs to be replaced with a fresh alkaline battery. Use non-rechargeable 9 Volt batteries.

Lithium Batteries are preferred.

Each remote used with a StagePro8 system must be configured identically. This allows the

system to be controlled exactly the same no matter which remote is sending commands and

ensures that the system stays in perfect synchronization. Once all remotes have been

configured, the last step is to verify that all remotes operate the StagePro8 the same way.

Remote Unit Power Button Operation (Body Packs and Floor Units)

 Power: Turns the unit on and off. Press once to turn power on. Hold for 2 seconds and

release to turn off.

 Edit: Enters Patch Edit Mode. Hold down the power button until the Red LED turns off

and the Green LED starts flashing rapidly. This takes about ten seconds.

 Clear: This will erase the contents of ALL patches programmed in the remote. When

entering patches in a new remote for the first time the memory should be CLEARED to

ensure that you are starting fresh. (We do this at the factory after testing, but it is still a

good idea to clear it again prior to starting out)

Channel Settings