User's Manual

Page 12

2. Set Mode Select to Patch (Center) position (on the remote that you are

programming) for channels 1, 2, 4, and AB (AB is always channel 6)

3. Press the Power button and verify that the power turns on. (Green LED will light

every few seconds)

4. To enter the Patch Edit mode, hold down the power button until the Red LED

turns off and the Green LED starts flashing rapidly. This takes about ten seconds.

5. Next, press the button that you want to assign the patch to. Press button 1 for

Patch 1.

6. The LED on Button 1 will flash once to confirm that you are Editing Patch 1. If the

LED on Button 1 stays on, this means that L1 will be part of the patch; which for

this example we do not want. To exclude or include L1 just press Button 1. Ensure

that Button 1’s LED is off (L1 excluded).

7. Next, press the button for each channel that you want to be part of patch 1

a. Press button 2 which controls L2 Chorus (LED 2 lights up to indicate that

it is part of this patch)

b. Press button 4 which controls L4 Delay (LED 4 lights up to indicate that it

is part of this patch)

Note: You can press any channel button again to de-select it or include it in

the patch (as long as its mode is set to patch). Also ensure that no other

LED’s are on, if they are, press their buttons to turn them off.

8. At this point LED 2 and LED 4 should be the only LEDs that are ON.

Note: Channel 1 is NOT part of this patch so its LED should be off.

9. To save these settings to Button 1 (Patch 1) press the power button once.

10. The remote now enters normal operation.

11. Test the new setting by turning on Main Unit then pressing Button 1 for Patch 1.

Note: If the main unit is not turned on the LED’s will not light on the Floor Unit.

They only light when the main unit confirms that the channels are truly on!

12. LED 1 should be slowly flashing (once per second). This indicates that you are

using Patch 1 and channel 1 is NOT part of the patch. If channel 1 was part of the

patch it would be flashing quickly (twice per second).

13. LED’s 2 and 4 should also now be lighted on the Main Unit and the Remote.