User's Manual

Page 5

 KK: The FXConnectX Proprietary Klick Killer. IN switches it into the audio chain, OUT

removes it. KK is inserted following the output of L4 and prior to the Buffer. Our KK is

a very unique and patent pending design which eliminates the maximum amount of

switch “Click” sounds while minimally affecting the quality of the audio signal. Most

times it isn’t even needed because our relays and relay circuits are so clean and quiet;

but it’s here if you need it.

 BFR: The FXConnectX custom built-in Buffer circuit is designed to prevent signal

loading and loss of definition of your guitar’s tone. Signal loading robs your high

frequencies. This loss is usually caused by vintage effects, cabling, or other number of

sources. Our Buffer has very low output impedance, high dynamic range, very low

noise, and very low distortion. Try it. When set to “IN” it is physically switched into the

audio chain with relays and when set to OUT it is completely out.

 12VDC Inputs: Twin DC inputs are provided as a dual-redundant feature to help reduce

the risk that a power supply could fail during a performance. Both can be plugged in

and operating at the same time. If one fails the other takes over and the show goes on.

Additional power supplies are available for purchase through our web site so that you

can take full advantage of this feature. This feature was requested by our Pro Artists.

 L-SW: Turns on the “Learn” mode which enables the StagePro8 to learn as many

compatible Floor Units or Body Packs as needed. This switch is internal. Use the tip of a

pen to activate. Press in very gently until the Lean LED illuminates. This button only

requires a very light press to activate it. Pressing too hard will damage the button.

When in Learn Mode the Learn LED’s on the front and rear panel will be illuminated. A

The main unit can learn any combination of Body Packs and Floor Units. Following are

the steps for leaning new remotes:

 Power up the main unit and the Remote Unit.