User's Manual

Page 6

 Ensure that only the Remote that is being learned is on and no other

(bandmate’s system, etc,) FXConnectX main units or remotes are on.

 Press the L-SW button on the Main Unit. The learn LED’s light up

indicating that the unit is now in learn mode.

 Press and release any button on the new Remote Unit to transmit the

security code until the Learn LED turns off on the main unit. (This must

be done within 5 seconds or the L-SW will need to be pressed again)

 Turn off the Remote Unit.

 Repeat for any additional Remotes.

 NOTE: To clear all learned remotes hold down the L-SW on the main

unit for 15 seconds until the LEARN LED’s extinguish. The memory will

now be cleared.

Rear Panel Connections Diagram

 SEND always goes to Effect INPUT and Effect OUTPUT goes to RETURN

 When powering up your rig/rack ensure that you turn on all of your effects. Effects

within each loop that are intended for use must be “ON” at all times. Rather than