User's Manual

Page 7

stomping on an effect to turn it on or off; the StagePro8 will now switch your effects into

and out of your audio chain for you at your command.

 Chain together any combination of effects on any single loop. There is no limit to how

many effects can be used on a loop. The same rules apply to signal integrity as if the

effects were hooked up directly to an amplifier’s main input or effects loop. The audio

and signal characteristics of the individual pedals/effects still apply regarding

impedance, coloring, pedal ordering (which one goes first, etc…), buffering, etc…

 For effects that are intended to be used on ALL loops simply insert that effect in the

chain prior to the main signal input coming into the StagePro8, or alternatively, place

these effects after the StagePro8’s output. This depends on how you prefer your chain

and sound. There are many possibilities.

 Sample Generic Pedal Order Scheme: Guitar, Tuner, Pre-Amp, Compression,

OD/Distortion, Noise Gate, Pitch Effects (Octave, Harmony, etc.), Modulation Effects

(Chorus, Flanger, Phaser, etc...), Delay Effects, Reverb.

o Chain Sample 1: “Analog Stage Simplicity”

 Guitar

 Tuner (ON using audio out ‘Bypass’ or Always ON jack)

 Compressor (with built-in buffer) – Output to StagePro8’s Input

 LOOP1: EQ and Distortion Pedal

 LOOP2: Chorus Pedal

 LOOP3: Phaser Pedal

 LOOP4: Delay Pedal

 AB to amp channel select

 TS2 to amp reverb on/off

 TS1 not used

o Sample 1 Channel Mode Selection Switch Settings

 Given the above chain, each of the above channels are intended to be part

of a patch. Set each channel’s Mode to the PATCH (Center) position on

each Remote unit intended for use. Mute is always on channel 5 and

should be set to Toggle or Momentary (your preference). TS1 is on channel

7 and TS2 is on channel 8.