User guide

ManualsBrandsApproved Optics ManualsRoutersApproved ADTRAN 1184561P4

1184561P4-A

1000Base-TX SFP Module

Copper Interface RJ45, 100m, RoHS6

Approved Optics, Inc. www.ApprovedOptics.com

Page 1 of 5

1184561P4-A

1.25Gbps SFP Transceiver

Features

• Support 1000BASE-T operation in host systems with SGMII

interface

• Up to 1.25Gbps bi-direction data links

• Fully metallic enclosure for low EMI

• Low power dissipation (1.05 W typical)

• Compact RJ-45 connector assembly

• Hot-pluggable SFP footprint

•100m transmission over unshielded twisted pair(UTP) Category 5 Cable

• Access to physical layer IC via 2-wire serial bus

Product Description

The 1184561P4-A 1000BASE-T Copper Small Form Pluggable (SFP) is based on the

SFP Multi Source Agreement (MSA). It is compatible with the Gigabit Ethernet and

1000BASE-T standards as specified in IEEE Std 802.3.

Absolute Maximum Ratings

Parameter Symbol Min. Max. Unit

Maximum Supply Voltage Vcc -0.5 4.0 V

Storage Temperature Ts -40 +85 °C

Summary of content (5 pages)

PAGE 1
184561P4-A 1000Base-TX SFP Module Copper Interface RJ45, 100m, RoHS6 1184561P4-A 1.25Gbps SFP Transceiver Features • Support 1000BASE-T operation in host systems with SGMII interface • Up to 1.25Gbps bi-direction data links • Fully metallic enclosure for low EMI • Low power dissipation (1.
PAGE 2
1184561P4-A 1000Base-TX SFP Module Copper Interface RJ45, 100m, RoHS6 Normal Operating Conditions Parameter Symbol Min. TA 0 VCC 3.14 Operating Temperature Supply Voltage Parameter Symbol Min Typical Max. Unit +70 3.3 Typ Max Units 300 350 mA 3.3 3.47 V 30 mA °C 3.46 V Notes/Conditions +3.3 Volt Electrical Power Interface Supply Current Icc Input Voltage Vcc Surge Current Isurge 3.13 Low-Speed Signals, Electronic Characteristics SFP Output LOW VOL 0 0.
PAGE 3
1184561P4-A 1000Base-TX SFP Module Copper Interface RJ45, 100m, RoHS6 Rx Output Impedance 50 Zout Ohm Single ended General specification Parameter Symbol Min Data rate Typ Max 1000 Distance Units Notes/Conditions Mbps 100 m Category 5 UTP. BER <10-12 Pin Descriptions Pin Num.
PAGE 4
1184561P4-A 1000Base-TX SFP Module Copper Interface RJ45, 100m, RoHS6 2. Should be pulled up with 4.7k – 10k Ohms on host board to a voltage between 2.0V and 3.6 V. MOD_DEF(0) pulls line low to indicate module is plugged in. Serial Communication Protocol This Copper SFP supports the 2-wire serial communication protocol outlined in the SFP MSA. These SFP use a 128 byte EEPROM with an address of A0h. The 1000BASE-T physical layer IC can also be accessed via the 2-wire serial bus at address ACh.
PAGE 5
1184561P4-A 1000Base-TX SFP Module Copper Interface RJ45, 100m, RoHS6 Contact Information Approved Optics is a leading supplier of Network Transceivers and Connectivity products to Channel Partners, Resellers, and OEMs. With more than 9 years of direct industry experience, our products are resident in the most demanding and mission critical functional networks Worldwide.