User Manual

www.apricorn.com
12
Adding a new User PIN
1. Enter the Admin Mode (UNLOCK + 0 for ve seconds. Enter Admin PIN and
press UNLOCK).
2. Press and hold UNLOCK + 1 until the LED turns to Solid BLUE and Blinking GREEN.
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of
16 digits). The LED ashes GREEN three times, then returns to Solid BLUE and
Blinking GREEN.
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid GREEN
for two seconds and then solid BLUE, the User PIN was successfully added.
Deleting the User PINs
You can delete all User PINs by doing the following:
1. Enter the Admin Mode (UNLOCK + 0 for ve seconds. Enter Admin PIN and
press UNLOCK).
2. Press and hold 7 + 8 + UNLOCK for ve seconds until the LED ashes
GREEN three times and then changes to BLUE / RED alternating.
3. Press and hold 7 + 8 + UNLOCK a second time for ve seconds until the
LED goes on solid GREEN for two seconds and then back to solid BLUE,
this indicates that the User PINs were deleted successfully.
Changing the User PIN
1. Unlock the drive by inputting your User PIN and pressing the UNLOCK button.
2. Press and hold UNLOCK + 1 until the LED ashes RED.
3. Enter your current PIN and press UNLOCK.
The LED will be Solid BLUE and Solid GREEN.
4. Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits
and a maximum of 16 digits). The LED will ash GREEN three times, then returns
to Solid BLUE and Blinking GREEN.
5. Re-enter the new User PIN and press UNLOCK. The LED stays solid GREEN
indicating that the User PIN has been changed successfully.