User guide

12
Setting a Self-Destruct PIN
1. Enter the Admin mode by pressing and holding UNLOCK + 0 for ve seconds until
the LED ashes RED. This indicates that you can enter the Admin PIN.
2. Enter the Admin PIN and press UNLOCK. The drive is in Admin Mode when the LED
has changed to BLUE.
3. Once in Admin mode, press UNLOCK + 3. LED will be alternating BLUE / RED.
4. Input in the PIN that you would like to use as the Self Destruct PIN and press
UNLOCK.
5. If the Self Destruct PIN is accepted the LED ashes GREEN.
6. Immediately re-enter the new PIN and press UNLOCK. If the LED stays solid
GREEN for two seconds and then goes to solid BLUE, the Self Destruct PIN was
added successfully.
7. To delete the Self Destruct PIN, you will need to delete all of the User PINs.
Disconnect and re-connect the drive, then refer to the instructions on the previous
page - Deleting User PINs.
Performing a Complete Re-Set
To perform a complete reset of the drive, do the following:
1. Press and hold the LOCK button while you attach the Aegis Padlock to an available
USB port on your computer. The LED will ash RED, GREEN and BLUE alternately.
2. Release the LOCK button.
3. FIRMLY Press and hold LOCK + UNLOCK + 2 for 10 seconds.
• If successful, the LED will turn Solid GREEN for two seconds, followed by
Solid BLUE and Solid GREEN.
• If unsuccessful, the LED will continue to cycle from RED to GREEN to
BLUE for 30 seconds and then return to Solid RED. To re-start the process.
Remove the USB cable and then repeat step 1.