User`s manual
17
Lock-Override Mode
Certain users may encounter a case where they need the key to remain
unlocked during a reboot, passing the key through a virtual machine or other
similar situation which, under normal circumstances, would cause the key to
lock. To help facilitate this use case, “Lock-Override Mode” will allow the key
to remain unlocked through USB port re-enumeration and will not lock again
until USB power is interrupted.
NOTE: When in this mode, the key is vulnerable to being moved from one
computer and connected to another computer provided USB power is
uninterrupted. Due to this vulnerability, we strongly recommend this mode be
used ONLY in circumstances where the key can be physically secured (as in
a locked Server Room) or in a place where it can be visually monitored while
in this mode. Use of a powered hub or a Y-cable increases this security risk.
Always return the key to the default Lock-Override Mode OFF when
returning to normal service.
To set the “Lock-Override” to On:
1. Enter the Admin Mode (Press and hold UNLOCK + 0 for ve seconds
until the RED LED blinks, then enter the Admin code and press the
UNLOCK button. The BLUE LED will glow solidly.)
2. Press and hold 7 + 1 for three seconds. the GREEN LED will blink three
times, then the BLUE LED will glow solidly.
3. When the key is unlocked and attached to a USB port in “Lock-Override
Mode”, the BLUE LED will blink once every three seconds to alert you
that “Lock-Override” mode is active.
Note: If “Unattended Auto-Lock” mode has been turned on, “Lock-Override”
will not override it; the key will lock itself upon reaching the selected amount
of inactivity. If you need the key to stay unlocked, Enter the Unattended
Auto-Lock Feature and set the lock timer to “0” (0 = OFF) See Page 10.
To turn Lock-Override Mode off and return to normal operation:
4. Enter the Admin Mode (Press and hold UNLOCK + 0 for ve seconds
until the RED LED blinks. Then enter the Admin code and press the
UNLOCK button. The BLUE LED will glow solidly.)
5. Press and hold 7 + 0 for three seconds. The GREEN LED will blink three
times then the BLUE LED will glow solidly.
6. To verify, unlock the key in User mode and check that the BLUE LED is
no longer blinking.