User`s manual

About the Aegis Secure Key 3.0

PINs must be a minimum of seven

digits and a maximum of 16 digits.

Cannot contain all sequential

numbers (e.g., 01234567, 9876543)

and cannot contain all of the same

number (e.g., 1111111, 2222222.)

Note: Sequentially, 0 occurs before 1, not after 9.

PIN Requirements

Important:

With its ash key size, the Aegis Secure Key also

has relatively small buttons. For greater ease and

better control of key commands, enter all PINs and

command codes onto the Secure Key’s keypad

PRIOR to plugging the device into the USB port for

use. Failure to do so may damage the USB port and

cause the key to not function properly.

Battery Note

The Aegis Secure Key has an internal

rechargeable battery with a smart-charging

circuit. For safety, each key ships with a partial

charge. Before initial use, we recommend

plugging the key into a powered USB port for

80 minutes to fully charge the battery. The

battery will automatically charge whenever it is

plugged into a powered USB port, regardless of

its operational mode. In standby mode, the RED

LED fades in and out slowly to indicate that it’s

charging and glows solid RED to indicate that

it’s fully charged. If the battery is completely

discharged, the key will go through a self-test

(indicated by a RED, GREEN, and BLUE LED

sequence) when plugged into a USB port.

Note: It’s normal for this device to

be warm to the touch during use.