User Guide

Before Using EZ-GIG

Before using EZ-GIG, it is important to perform the following

tasks:

- Backup the data on your original hard drive(s).

- Check for file system errors by running ScanDisk (through mode)

or any disk utility program.

- Any Virus Protection program must be uninstalled and reinstalled

onto the new hard drive after completing the upgrade.

- Check your notebook manufacturers website for the latest BIOS

update. If an update is needed, do this before using EZ-GIG.

- It is recommended that the EZ-GIG software only be run while your

notebook computer is running on AC power adapter. Battery power

may run out during file transfer.

Safety Instructions

- Observe proper ESD (Electo-Static Discharge) handling techniques

at all times. Keep hard drive in the antistatic bag until you are ready

to install it.

- Do not open the drive or make modifications to the drive mechanism.

- Do not drop or jar the drive. Handle by the edges or frame.

- When transporting the hard drive, always use the external case

provided.