User Guide

4
Figure 4
Chapter 1: EZ-GIG Installation
Below is an example of what will be displayed on your screen:
Source Drive: Destination Drive
Internal, Primary IDE, Master External, PCMCIA Socket0, Master
TOSHIBA MK2104MAV IBM-DCXA-21000
Serial number: 77S50007 Serial number: PR2PRB00826
Firmware rev: E4.00 A Firmware rev: CX60A8AF
Actual C/H/S: 4200/16/63 Actual C/H/S: 16383/16/63
Logical C/H/S: 525/128/63 Logical C/H/S: 1299/240/63
Megabytes: 2167 Megabytes: 10056
Access mode: BIOS, CHS Access Mode: IDE direct, LBA
Begin Transfer?(Y/N or CTRL-U for Utility menu) >
Figure 3
7) You are now ready to start the data transfer by pressing “Y” or for
additional features, press “Ctrl-U” to access the utilities menu. (See
Appendix B for Utilities Menu).
8) Your screen will display the following: When you see the spinning
character begin to move, the transfer is under way.
Press <CTRL-Q> to cancel process
Copying partition 1 of 1, gathering information ... 1
9) When the data transfer is complete, the following will be
displayed on your screen. (See figure 4). Remove the floppy
diskette and turn off your notebook.
Elapsed time (hr:min:sec):
Data has been successfully transferred.
Remove floppy diskette, turn computer off and install new drive.
10) Remove the EZ-GIG PC Card from the PCMCIA slot.
11) Carefully remove the hard drive from the end of the EZ-GIG PC
Card cable.
12) Remove your old hard drive from your notebooks hard drive bay.
Hard Drive Installation instructions are located on the EZ-GIG software
diskette (A:/installs.htm), if you do not see your particular notebook listed
refer to your computer’s user guide.
13) Install your new hard drive.