Upgrade Kit for Desktop PCs Owner's manual

www.apricorn.com

SATA

Data Cable

SATA III Connector for optional expansion

to another SATA drive

Connect to your

compute

r’s

power supply

Power cable

Any SATA Drive

2.5” or 3.5” /

DD or SSD

Disk Drive

Power cable

SATA cable

SATA connector

Power connector

Optional - Connecting an additional drive to

the Velocity Solo SATA III connector

1. Using a SATA data cable connect an additional drive to the SATA III

port on the Velocity Solo card, as shown in Figure 2.

2. Using a power cable connect the drive to your computer’s power

supply, as shown below.

Verifying Velocity Solo Installation

1. After the Velocity Solo is installed, replace the chassis cover,

reconnect the power cord(s) and boot the computer.

2. If the installation is successful, the system conrms detection of the

Velocity Solo drive with on screen messages while the drivers are

automatically installed.

3. If the Velocity Solo drive is not detected, check the drive and cable

connections and ensure that the Velocity Solo is installed correctly in

the PCIe slot.

For Windows XP owners, please visit the Velocity Solo

product page at:

www.Apricorn.com to download Windows XP Drivers.

Figure 2. Connecting the Velocity Solo to a HDD or SSD

Cloning your Internal Drive to the Velocity Solo

Once the Velocity Solo installation is complete, restart your system and

download Apricorn’s EZ Gig cloning software at the site below:

CLONING SOFTWARE DOWNLOAD

Apricorn EZ Gig Software for Windows®

http://www.apricorn.com/ezgig/