User`s guide

5
www.apricorn.com
Connecting your SSD to the Velocity Solo Card
Slide your SSD onto the SATA connector on the Velocity Solo Card.1.
Use the included mounting screws to secure the drive in place. 2.
Slide your SSD
onto the SATA
connector on the
Velocity Solo Card.
Use mounting
screws to secure
the drive in place.
SATA connector
Installing the Velocity Solo in your desktop
computer
Before installing your drive, take note of the drive’s part number, located 1.
on the sticker on the front of the drive. This is will come in handy when
choosing the destination drive when cloning your drive with EZ Gig.
Power-down the system and physically remove power cord(s) from the 2.
system.
Remove the cover from the 3.
system’s chassis, following
instructions provided by the
manufacturer.
Select an available PCIe Gen 4.
1 / Gen 2 (x1, x2, x4 or x8)
slot and insert the Velocity
Solo card into the slot, as
shown in Figure 1.
Hold the Velocity Solo card 5.
at the edges and press down
gently into place.
Secure the Velocity Solo 6.
metal bracket to the system
chassis by tightening the slot
screw.
P
C
Ie
G
e
n
1
/G
e
n
2
(x
1
, x
2
, x
4
o
r x
8
s
lo
t)