Installation Sheet

–6– –11–
FIGURE 8
Fasten hanging “hook” bracket (furnished) securely to left end of unit with 10-32 machine screws
3
⁄8" long
(furnished) using pre-tapped holes along top left edge of unit. Fasten hanging “hinge” bracket to right
edge. Be sure both brackets face outward from unit. Insert hanging pin in left hole of mounting bracket
and hand tightened with threaded nut.
FIGURE 9
For the ceiling installation lift
the unit with the blower end
against you. Left hand should
be under the top edge and
right hand should be under
the lower right corner as
shown in the drawing. Tilt the
far end up toward the mount-
ing bracket and “hook” the
hanging “hook” bracket over
the hanging pin.
FIGURE 2
HANGING HOOK
BRACKET
UNIT
ACCESS DOOR
MOUNTING BRACKET
HANGING HINGE
BRACKET
WARRANTY
CARD
LAG BOLTS &
WASHERS
OWNERS
MANUAL
MACHINE
SCREWS
HANGING PINS &
THREADED NUTS
Energy Recovery Ventilator Components
INSTALL HOOK ONTO
APRILAIRE
®
Energy
Recovery Ventilator
INSTALL HINGE ONTO
APRILAIRE
®
Energy
Recovery Ventilator
INSERT HANGING PIN
INTO MOUNTING CHANNEL