Owner`s manual

CYCLE PARTS
5 - 30
SR 50
5.7.3. DISASSEMBLING THE STANCHION
• Remove the stanchion assembly, see (REMOVING
THE FORK LEG).
CAUTION Prepare a graduated receptacle with a capacity of
at least 300 cm
3
(18.31 in
3
.).
• Let the fork leg enter the stanchion completely, turn the
stanchion assembly and let the fluid drain in the
container.
WARNING
Check the oil level. If lower than 103 cm
3
(6.28
in
3
), top up or change.
• Loosen and remove the screw (1) (bottom end) and
collect the copper washer (2).
• Slide out the slider (3) with damper (4).
• Turn the stanchion (5), collect the buffer (6) and the
counter spring (7).
• Remove the dust seal (8).
• Remove the circlip (9).
WARNING
While reassembling, fit the circlip (9) with the
sharp edge fully home (see figure).
• Remove the seal (10).