Specifications

Electrical system

chap. 6

6-37

Release 00 2002-09

Atlantic 500

• Loosen and remove the two screws (3) that fasten

the protective shield (4) of the third stop light.

• Slide the all-glass bulb (5) from its socket.

• Correctly fit a bulb of the same type.

CAUTION

NOTE On reassembly, place the protective shield

correctly in its seat.

Tighten the screw (3) slightly and with care to

avoid damaging the protective shield.

VERTICAL ADJUSTMENT HEADLIGHT

BEAM

• To quickly check the correct adjustment of the

beam, place the vehicle on flat ground, 32.81 ft

(10 m) away from a wall.

• Switch on the headlight, sit on the vehicle and

make sure that the headlight beam projected onto

the wall is just below the horizontal line of the

projector (approximately 9/10 of the total height).

To adjust the headlight beam:

• Adjust the knob (1) provided from the front of the

vehicle.

• Turn CLOCKWISE to adjust the beam higher.

• Turn COUNTER-CLOCKWISE to adjust the beam

lower.